Build Guide - GC Ultimate Kickstarter Edition

Build Precautions

Please read all of these precautions before viewing our build guide

Watch the entirety of the build guide videos before starting your own build.

The shorter T6 screws are a bit short and have a light grip on the internal posts.
Only tighten these screws gently to hold the PCBs to the front shell.
These do not need to be too tight, otherwise you will run the risk of stripping the threads.
Do NOT overtighten these screws.
The larger T8 screws are fine and you can tighten these with more confidence.

Install a small cut out square of cotton pad into your shell to help produce better transfer of vibrations from the actuator to the shell.

Here’s an example of the size square for each side.

And here’s where I recommend installing these before assembly.

Watch this FULL video to see how the whole controller is assembled first.

If you are setting up your GC Ultimate controller to be built with mechanical triggers, watch this video guide.

Proceed to our User Guide for more details on how to use your GC Ultimate.