Capacitor Diagnostic

If you're unsure about whether your GBA console needs a recap, you can test the voltage at these points associated with each electrolytic capacitor.

Unless you have a power supply, measuring the capacitors can be a difficult task unless you know exactly where to probe. We've laid out these locations below so you can test the voltages with AA batteries in the GBA housing (Which blocks the rear side of the PCB).

Measurements are performed with a multimeter in DC voltage mode. Read your multimeter's manual for full details on setup for your device.

Your black probe can be placed on the negative battery terminal labelled BT- on the PCB. Your red probe would go to the point for which you are measuring voltage.

If your readout is significantly less than the voltages listed, the respective capacitor likely needs replacing.

Located near SELECT/START

Measurement Locations

CP1

Located near SELECT/START

CP2

Located below D-Pad RIGHT

CP3

Located just above START

CP4

Located near headphone jack

Capacitor Measurements

The following measurements were performed on a known working board that has been recapped.

Citations

Board scans - https://circuit-board.de/forum/index.php/Thread/13913-STRIP-CLUB-PCB-Scans/?pageNo=1