Disassembly Guide (GBA SP)

This is our guide on disassembling the Game Boy Advance SP.

Video Guide

https://www.youtube.com/watch?v=PdcRxr3GdC0

Getting Started

Required Tools

  • Y0 Tri-point screwdriver

  • J0 screwdriver

  • Plastic spudger

  • Tweezers/Needle Nose Pliers

Disassembly

Back Cover

Use the J0 screwdriver to unscrew the battery pack cover on the rear side of the console. Remove the battery.

Use the Y0 screwdriver to remove the 6 screws holding the rear cover on. Note the two shorter screws and their locations.

The rear cover lifts up to reveal the main board. Remove the power switch and place it aside.

Main Board

Remove the 3 gold colored J0 screws holding the main board to the front shell.

Carefully tilt the main board up and away from the front shell. The display ribbon cable is still attached to the main board, which we'll remove next.

Use your plastic spudger tool to unclip the display ribbon cable.

The main board can be removed and placed aside.

Display Assembly

Remove the buttons, membranes, speaker, and speaker cover.

Remove the longer J0 screw hidden underneath the display ribbon cable. This screw holds down the hinge cover. Remove the hinge cover and place it aside.

Turn the console over and examine the LCD border. There are 5 screws hidden under rubber covers. Use either your plastic spudger or tweezers to lift away these rubber pads. If you want to reuse the rubber pads, take extra care to not rip or tear these pads. Having a set of spare pads on hand is recommended.

Remove the 5 Y0 screws.

Close the clamshell lid and lift away the rear LCD cover. The LCD can be removed at this point. The ribbon cable can be carefully threaded through the front shell.

Rear screen shell removed

Rear screen shell removed

LCD removed

LCD removed

Hinge Removal (Optional)

As an optional step, you can remove the screen hinges. There are plastic clips holding the hinges in that need to be depressed using a plastic spudger tool or a screwdriver.

Tabs may break!

Tabs may break!

Open the front LCD cover. At this point the hinges can be fully removed.

The hinges have a small plastic cap that slides off.

Conclusion

To reassemble your console, simply follow these steps in reverse.