Four Pikachus Issue

Problem

Observing 4 Pikachus after installing and powering up your Game Boy DMG or GBP:

• The IPS LCD and PCB are not getting adequate power.

• No LCD signal is being received from the PCB.

Solutions

• Disconnect and reconnect all cables and ribbons. It can take a couple tries to make the proper connection.

• Look for cable or pin damage, especially on the large ribbon cable. We have spares available here.

• Double check that all your ribbon cables are fully secured/completely inserted/ports cleared of all debris/dust. It's possible a cable has a little more lead that needs to be inserted into the port or a latch on a port is loose.

• Clean all your contacts, cables, and ports with 91% or higher isopropyl alcohol - 99% preferred.

• Clean your power switch.

• The capacitors on the console may need to be replaced. Proceed with a capacitor diagnostic on your console. If you find your readouts are off, you may need to recap your console.

• Consider purchasing a new Power Board (Regulator) for your console.

If you continue to see this issue, please reach out to support@handheldlegend.com