# Four Pikachus Issue

### Problem

Observing 4 Pikachus after installing and powering up your Game Boy DMG or GBP:

* The IPS LCD and PCB are not getting adequate power.
* No LCD signal is being received from the PCB.

### Solutions

* Disconnect and reconnect all cables and ribbons. It can take a couple tries to make the proper connection.
* Look for cable or pin damage, especially on the large ribbon cable. We have [spares available here.](https://handheldlegend.com/products/ribbon-cable-for-game-boy-dmg-ips-pcb?_pos=4&_sid=acd14af23&_ss=r)
* Double check that all your ribbon cables are fully secured/completely inserted/ports cleared of all debris/dust. It's possible a cable has a little more lead that needs to be inserted into the port or a latch on a port is loose.
* Clean all your contacts, cables, and ports with 91% or higher isopropyl alcohol - 99% preferred.
* [Clean your power switch.](https://wiki.handheldlegend.com/power-switch-cleaning-guide)
* The capacitors on the console may need to be replaced. Proceed with a capacitor diagnostic on your console. If you find your readouts are off, you may need to [recap your console.](https://wiki.handheldlegend.com/electrolytic-re-cap-guide)
* Consider purchasing a new [Power Board (Regulator)](https://handheldlegend.com/products/cleanpower-regulator-board-for-game-boy-original-dmg) for your console.

If you continue to see this issue, please reach out to support@handheldlegend.com