HOJA FW Installation Guide
Getting Started
If you need to wipe your controller configuration and start fresh, download this Nuke.uf2 firmware file. Otherwise, if you are only updating, you may ignore this step.
Put your gamepad into USB bootloader mode
To enter the USB bootloader, hold L and Plus while connecting via USB.
For GC Ultimate, this is Plus and the left Z button.
For Super Gamepad+, this is Start and L trigger.
If you are performing a full configuration wipe, drag the nuke.uf2 you just downloaded to the RPI-RP2 device in your file explorer. The device will disconnect and reboot and again display as a USB drive device.
Download the firmware for your device
Installing the wrong firmware will result in needing to disassemble your device to enter USB bootloader to properly install the firmware.
Device | Firmware |
|---|---|
ProGCC V3 (Original) | |
ProGCC V3+ | |
ProGCC V3.1 (Wired/Wireless) | |
ProGCC V3.2 (Wired/Wireless) | |
Super Gamepad+ | |
GC Ultimate (Prototype Edition) | |
GC Ultimate R4K (Kickstarter and newer) | |
Phob 2 |
STOP. Double check the file name of the firmware you are copying.
Copy the CORRECT firmware for your device to the RPI-UF2 device.
Configure Your Gamepad
The new app can be found here.
Note that this app is under development and may have bugs or inefficiencies.
Discord is the best place to report issues!
Wireless Pairing
To pair with the new firmware, power on, then hold the Sync button until the controller restarts into pairing mode.
The old method, holding Plus (+) while booting will enable pair mode.