ProGCC 3+ / 3.1 / 3.2
The ProGCC 3+, 3.1 and 3.2 are the wireless ProGCC boards: a Pro Controller-style board with Bluetooth through an ESP32 wireless module, a battery, and ports for real consoles. All three work the same way. The ProGCC 3.2 also comes in a wired-only version, without the battery and wireless module: it uses the same ProGCC 3.2 firmware, and everything on this page applies except power, pairing and the wireless module. They run HOJA firmware and are configured with HHL Gamepad Config. For the wired boards, see ProGCC 3 / 3S.
Wireless | Bluetooth (Switch, Steam, and Wii after the wireless module update) |
Wired | USB-C, plus GameCube, N64 and SNES/NES with a Retro-C cable |
Battery | 1200 mAh (Pro Controller pack), rechargeable over USB-C |
Extras | Gyro, rumble, RGB lighting |
Power
Turn on (wireless): hold the right stick in for a few seconds until the controller turns on.
Turn off: hold right stick click + Home for 3 seconds, then let go.
Frozen? Hold the right stick in for 15 seconds to force a restart.
Sync button
Tap Sync to turn tournament mode on or off. It disables the D-pad, Home, Plus, Minus and Capture, so they can't be pressed by accident in a match. The LEDs flash green when it turns on and red when it turns off.
Hold Sync for 3 seconds to start Bluetooth pairing.
Modes and pairing
Hold a button while you turn the controller on or plug it in. Full table and steps: Modes & Pairing.
Hold | Mode | Wireless |
|---|---|---|
A | Switch | Bluetooth. Pair: A + Plus |
B | Steam | Bluetooth. Pair: B + Plus |
X | XInput | Wired only |
Y | Slippi | Wired only |
D-pad Up | Wii | Bluetooth (with the HCI bridge). Pair: D-pad Up + Plus, then SYNC on the Wii |
D-pad Right | GameCube | Wired only |
D-pad Down | N64 | Wired only |
D-pad Left | SNES / NES | Wired only |
Updating
These boards have two firmwares: the controller's, and the wireless module's. Update the controller first, then the module.
Controller firmware: connect to hoja.handheldlegend.com and press Update now when offered. Update mode by hand: hold L + Plus while plugging in. See Update Firmware.
Wireless module: from the Wireless page. Update mode by hand: hold R + Plus while plugging in (the lights pulse orange). See Update the Wireless Module. Afterwards, pair your Switch and other devices again once.
When installing on a blank board, pick your exact board: ProGCC 3+, ProGCC 3.1 or ProGCC 3.2.