Trigger Settings

The settings that you see will depend on the function of your gamepad. For example, ProGCC does not feature any analog triggers, while GC Ultimate does.

Analog Trigger Calibration

Click ‘Calibrate’, then press and release the analog triggers fully. Press stop, and be sure to Save after verifying the results.

Left/Right Trigger

Analog Mode

Enable or disable the analog function of your ZL/ZR triggers.

Digital Threshold

This determines at which analog value a digital press will be sent (Useful for Nintendo Switch or retro modes).

Deadzone

This determines the minimum value your analog trigger must reach before it begins to output any signal.

Split Press Value

For GameCube compatible modes, there is a Special Function button that can be freely bound. If, for example, you wanted to use a mode where your Light and Full analog presses are spread between two buttons, this setting allows you to customize where the light value falls.

GameCube Setting

This will determine the Special Function mode (GameCube/Slippi modes only).