The GC Ultimate Kickstarter Edition features both wireless and wired features.

Switch Mode (USB)

Locate and enter System Settings.

Scroll down until you see Controllers and Sensors.

Press A, then locate and enable Pro Controller Wired Communication.

You will see a prompt about NFC functionality, press OK.

You now have Pro Controller Wired Communications enabled.

Configuration

Configuration includes calibrating the analog sticks, setting your RGB colors, and more.

To adjust the settings on your controller, refer to our Hoja 2 Config Tool guide.

Analog Stick Calibration

Analog Trigger Calibration

Wired Mode

Simply connect your controller via a USB-C cable to enable wired modes.

Holding down one of the alternate mode buttons while plugging in will boot into the desired mode.

Wireless Mode

Power On

To power on the controller in wireless mode, hold the Power button until the controller turns on. The LEDs will flash to indicate you are in wireless mode. See the modes explainer for the corresponding colors.

Holding down one of the alternate mode buttons while powering on the controller will boot into the desired mode.

Pairing

To pair your controller to Nintendo Switch consoles, go to Find Controllers > Change Grip/Order from the Switch home screen menu.

Hold the Plus Button while powering on the controller to enable pairing mode. The controller will connect. The connection is remembered the next time you power on your controller.

Power Off

Simply hold the Power button until the power shuts off.

Modes Explainer

Hold the appropriate button while powering on the controller (Wireless Mode) or while plugging the controller in via USB.