Super Gamepad+
The Super Gamepad+ is an SNES-style controller with Bluetooth, USB-C and Retro-C ports for real consoles. It runs HOJA firmware and is configured with HHL Gamepad Config.
Wireless | Bluetooth (Switch, Steam, and Wii after the wireless module update) |
Wired | USB-C, plus SNES/NES, N64 and GameCube with a Retro-C cable |
Battery | Rechargeable over USB-C |
Power
Turn on: hold Select for a few seconds until the controller turns on.
Turn off: hold Select for 3 seconds, then let go.
Plugged into USB, it turns on and runs wired.
Home and Capture
The Super Gamepad+ has no Home or Capture buttons. Use:
Select + R for Home
Select + L for Capture
These don't apply in SNES mode, and L + R + Select + Start (the soft-reset combo many SNES games use) passes through unchanged.
Modes
Hold a button while you turn the controller on or plug it in. The full table is on Modes & Pairing.
Hold | Mode | Use it for |
|---|---|---|
A | Switch | Nintendo Switch, phones and tablets, HHL Gamepad Config |
B | Steam | PC and Steam Deck, HHL Gamepad Config |
X | XInput | Windows PCs, wired |
Y | Slippi | Slippi / Dolphin, wired |
D-pad Left | SNES / NES | A real SNES or NES, with a Retro-C cable |
D-pad Down | N64 | A real N64, with a Retro-C cable |
D-pad Right | GameCube | A real GameCube or Wii, with a Retro-C cable |
D-pad Up | Wii | A Wii, as a Wii Remote (needs the HCI bridge wireless firmware) |
With no button held, it starts in its default mode (Auto on current firmware), which you can change on the Gamepad page of the app.
Pairing
Switch, phone or tablet: hold A + Start while you turn it on.
PC or Steam Deck: hold B + Start while you turn it on, then pair from the Bluetooth settings.
Wii: hold D-pad Up + Start, then press SYNC on the Wii.
Full steps: Modes & Pairing.
Updating
The Super Gamepad+ has two firmwares: the controller's, and the wireless module's.
Controller firmware: connect to hoja.handheldlegend.com and press Update now when offered. Update mode by hand: hold L + Start while plugging in. See Update Firmware.
Wireless module: update it from the Wireless page, after the controller firmware. Update mode by hand: hold R + Start while plugging in (the lights pulse orange). See Update the Wireless Module.
More
Settings Guide: what each page of the app does.